BYG310 Structural design lll - Wood
- ECTS Credits:
- 7.5
- Responsible department:
- Faculty of Engineering and Science
- Course Leader:
- Preben Aanensen
- Lecture Semester:
- Autumn
- Teaching language:
- Norwegian
- Duration:
- 1 term
Teaching language
NorwegianRecommended prerequisites
BYG125 Building Materials
BYG228 Structural Mechanics II
BYG307 Structural Mechanics III
BYG222 Loads and Structures
BYG227 Building Design
or similar
Course contents
-
Dimensioning of wood elements for different loads and load combinations (pressure, tension, shear, and torque) in accordance with European regulations (Eurocode 5)
-
Calculation, dimensioning of nodes in wood in accordance with European regulations (Eurocode 5)
-
Introduction to wood and wood-based products
-
Wood as construction material
Learning outcomes
After completing the course the student should:
-
Understand non-isotropic materials
-
Be able to explain and convey the advantages and disadvantages of using wood as material for given constructions
-
Be able to design relevant wooden structural parts
-
Be able to design different nodes in wood
-
Be able to verify that requirements for strength and stiffness are met in accordance with European regulations (Eurocode 5)
-
Have a good understanding of building structures
-
Have a good understanding of wood as a building material
-
Have the knowledge to evaluate when wood is a better choice as building material than other building materials
-
Have knowledge of typical wood support systems
Examination requirements
Students must pass the compulsory assignments to take the examination.
Teaching methods
Lectures, exercises.
Evaluation
The person responsible for the course decides, in cooperation with student representative, the form of student evaluation and whether the course is to have a midway or end of course evaluation in accordance with the quality system for education, chapter 4.1.”
Offered as Single Standing Module
Yes. Subject to availability or capacity.
Assessment methods and criteria
Individual 4 hours written exam. Graded assessment.
Reduction of Credits
This course’s contents overlap with the following courses. A reduction of credits will occur if one of these courses is taken in addition:
| Course | Reduction of Credits |
|---|---|
| BYG306 – Structural design 3 - steel and wood | 5 |